- #Loopman sd hc manual software#
- #Loopman sd hc manual Pc#
- #Loopman sd hc manual download#
Thank you for choosing the xTool products!
For more information about after-sales services, visit. If you can't provide a valid invoice, the warranty period will calculate from the factory date. The invoice date will appear as a reference. The warranty period in the preceding table is as defined from the date of purchase on the receipt. Power cord, USB cable, consumable parts, user guide card, package, etc. Note: To extend the functions of xTool D1, you need to purchase the required parts and components. Place the module parallel to and in the working area of xTool D1 and connect it to xTool D1 through the extension port.įor details, see the tutorial for the rotary attachment. You can add the rotary attachment to engrave cylindrical items. You advise wearing safety goggles to protect your eyes. You can adjust the material section to ensure that the practice takes root was expecting it. Click the start button in the upper right corner, and then click Framing to preview the pattern's position to be engraved on the material. Place the material to be engraved in the working area of xTool D1 and set the position of the laser head based on the focus ruler. Import the pattern you want to engrave and set the pattern size and laser parameters. 
After xTool D1 is successfully connected, the device icon in the upper right corner turns green. After setting the Wi-Fi network, tap OK. Wait till the app discovers your device. Open the app on your mobile device and tap the device icon in the upper right corner. Connect your mobile device to the same Wi-Fi network as your PC. Select your device in the dialog box that appears, and then set the Wi-Fi name and password. #Loopman sd hc manual software#
Open the software on your PC, click the Not Connected drop-down list box, and select + Configure and add the device. #Loopman sd hc manual download#
Search for Laserbox in an app store and download it.After Wi-Fi mode connects in xTool D1, you can remove the USB cable to control it wirelessly.
#Loopman sd hc manual Pc#
Note: Make sure that xTool D1 and your PC work on the same LAN. Select + Configure and add the device to use the Wi-Fi mode, select your device in the dialog box that appears, and then set the Wi-Fi name and password. To use the USB connection mode, select your device.
Open the software, and click the Not Connected drop-down list box to select a connection mode. Use the USB cable to connect xTool D1 to your PC. Insert the motor & laser cables into the ports on the main control board. Note: Use cable ties to fit the cable on the plate so that the cable doesn't interfere with the operation of xTool D1. Note: Press the connectors of the motor cable into place to prevent poor contact. Use the motor cable to connect the motor on the left plate to the main control board. (2) Put the timing pulley through the timing belt, and then tighten the screws on the coupling. 
(1) Drag the middle plate to make it close to the rear plate.
Use the screw to set the tightness of the timing belt on the middle plate. Otherwise, the material can't carve adequately. Make sure that you set the timing belts on the left and proper plates with the same tightness. Otherwise, the timing belts may be damaged. Do not fully tighten the most extended extension. The purpose of the most extended extension screw is to set the tension of the timing belt. Use screws to set the tightness of the timing belts on the left and proper plates. Before you pull the screws, press each joint of the plates to ensure no support hangs in the air. Align a screw with the screw hole before tightening it. Tighten screws at each joint of the plates to fix them together. 
Fit the four side plates together on a desk or flat ground. Cut off the cable tie on the right plate.
0 kommentar(er)
